Toro Greensmaster Flex 1018 Service Manual page 111

Removing the Brake Cable (continued)
Greensmaster ® Flex 1018/1021
20247SL Rev A
g261858
1. Retaining ring
2. Cable eyelet
3. Remove the brake cable (item 5 in
the transmission gear box assembly as follows:
A. Loosen the front cable jam nut (4) that secures the brake cable to the
casting slot on the transmission gear box assembly. Remove the brake
cable from the slot.
B. Remove the retaining ring (1) that secures the cable eyelet (2) to the
brake lever (3) on the transmission gear box assembly.
C. Remove the brake cable eyelet (2) from the brake lever (3).
4. Remove the control cover and lower cover from the handle assembly to allow
access to upper end of the brake cable.
5. Remove the brake cable (item 9 in
as follows:
A. Loosen the lower brake cable jam nut (8) that secures the brake cable
(9) to the upper receiver weldment (4). Slide the brake cable from the
upper receiver weldment.
B. Remove the brake cable spring (7) from the spring anchor on the brake
lever assembly (3). Note the orientation of the brake cable spring hook
on the brake lever assembly for assembly purpose.
6. Remove the brake cable (9) from the machine.
Figure 51
3. Brake lever
4. Jam nut
Figure 51) from the brake lever shaft on
Figure 50) from the brake lever assembly
Page 7–7 Controls, Wheels and Accessories : Service and Repairs
5. Brake cable