Toro Greensmaster Flex 1018 Service Manual page 159

Installing the Front Roller (continued)
Removing the Rear Roller
Installing the Rear Roller
Greensmaster ® Flex 1018/1021
20247SL Rev A
6. Center the front roller in the cutting unit and tighten the pinch bolts that
secure the front roller shaft to the height-of-cut arms.
7. Adjust the cutting unit height-of-cut; refer to the Cutting Unit Operator's
Manual.
g313146
1. Rear roller assembly
2. Flange nut (2 each)
3. Shim
Refer to Figure 84 for this procedure.
1. Remove the cutting unit from the machine and place it on a level work surface.
Place blocks under the bedbar to raise the rear roller off of the work surface.
2. Loosen the flange nuts that secure the rear roller retainer assemblies (flange
nuts, socket head screws, shaft retainer, spacer and shims) to the cutting unit.
Note: On cutting units equipped with the optional High Height-of-Cut Kit,
there will be additional roller shims installed between the rear roller and the
cutting unit side plate.
3. Remove one of the rear roller retainer assemblies.
4. Slide the rear roller assembly from the remaining retainer assembly.
5. Remove the remaining retainer assembly from the cutting unit if necessary.
Refer to Figure 84 for this procedure.
1. Place the cutting unit on a level work surface. Place blocks under the bedbar
to raise the rear of the cutting unit off of the work surface.
Note: Refer to the Cutting Unit Operator's Manual to determine the number
of shims required for the desired height-of-cut range.
2. If previously removed, install one of the rear roller retainer assemblies (flange
nuts, socket head screws, shaft retainer, spacer and shims) to the cutting unit.
3. Slide the rear roller shaft into the retainer assembly attached to the cutting
unit.
4. Install the remaining rear roller retainer assembly.
Figure 84
4. Spacer
5. Shaft retainer
6. Socket head screw (2 each)
Page 8–23 DPA Cutting Units: Service and Repairs