Toro Greensmaster Flex 1018 Service Manual page 63

Installing the Reel Drive Assembly
g312504
1. Retaining ring must be fully seated
Greensmaster ® Flex 1018/1021
20247SL Rev A
Note: Refer to Figure 22
1. Use a press to install the 4 ball bearings (items 2 and 5 in
reel drive housing (6).
2. Secure the ball bearings with 2 retaining rings (item 3 and 4 in
into the reel drive housing (6).
3. Install the bearing shield (11) into the reel drive housing (25).
4. Slide the reel shaft driver (13) into the reel drive housing (25).
5. Slide the spacer (9) into the reel drive housing (25).
6. Install the hipro key (12) onto the reel shaft driver (13). Apply anti-seize
lubricant on top of the key.
7. Install the reel pulley (8) onto the reel shaft driver (13). Secure the reel pulley
(8) with the lock nut (7).
8. Torque tighten the lock nut to 36.6 to 44.7 N∙m (27 to 33 ft-lb).
9. If removed, install the new O-ring (20) onto the pivot sleeve.
10. Slide the reel shaft driven (22) into the reel drive housing (25).
11. Slide the spacer (9) into the reel drive housing (25).
12. Install the hipro key (12) onto the reel shaft driven (22). Apply anti-seize
lubricant on top of the key.
13. Install the reel pulley (27) onto the reel shaft driven (22). Secure the reel
pulley (27) with the lock nut (7).
14. Torque tighten the lock nut to 36.6 to 44.7 N∙m (27 to 33 ft-lb).
15. If removed, install the bushing (29) into the idler arm (28).
16. If removed, use a press to install the 2 ball bearings (5) onto the idler arm
(28) and secure the ball bearings with a retaining ring (4).
17. Install and secure the idler am (28) into the reel drive housing (25) with
socket head screw (30) and nut (23).
18. Install the carriage bolt (6), washer (24) and nut (18) to the idler arm (28) and
reel drive housing (25). Do not tighten the nut (18).
19. Place the V-ring seal (21) into the reel drive housing (25).
20. Attach a new gasket (3) onto the reel drive housing (25).
21. Install the reel drive housing (25) onto the cutting deck and secure with the
bolt (10), 2 socket head screws (26) and nuts (19).
22. If removed, install the expansion plug (1) into the reel drive cover (2).
23. Install the reel drive belt; refer to
during the procedure.
Figure 24
2. Press sleeve to shoulder
Installing the Reel Drive Belt (page
Page 5–9 Traction and Reel Drive Systems: Service and Repairs
Figure 23) into the
Figure 23)
5–6).