Toro Greensmaster Flex 1018 Service Manual page 108

Removing the Throttle Cable (continued)
Controls, Wheels and Accessories : Service and Repairs
g261801
1. Governor lever
2. Throttle cable
2. Remove the throttle cable (item 2 in
linkage (1) as follows:
A. Loosen the screw that secures the cable clamp (3) to engine bracket.
Remove the throttle cable (2) from the cable clamp (3).
B. Loosen the screws that secure the throttle cable (2) to the governor lever
(1). Slide the throttle cable from the governor lever.
C. Separate the throttle cable (2) from the engine.
3. Remove the control cover and lower cover from the handle assembly to allow
access to upper end of the throttle cable (item 3 in
4. Remove the throttle arm from the handle assembly. Loosen the lock nut (2)
on the throttle cable and slide the throttle cable and throttle arm from the
upper receiver weldment (1).
5. Remove the throttle cable from the throttle arm.
6. Remove the throttle cable from the machine.
Figure 49
3. Cable clamp
4. High speed screw
Figure
Page 7–4
49) from the engine governor
Figure 48).
Greensmaster ® Flex 1018/1021
20247SL Rev A