Epson EPL-6200 Network Manual page 67

Network Guide
Instructions for using NetWare
Printing a text file
When you print a text file using the NPRINT command of NetWare or DOS, redirection,
misconversion or a gap in characters may occur depending on the client environment.
IPX routing protocol "NLSP"
It is possible to set the IPX routing protocol "NLSP" from NetWare 4.x or later; however, the
network interface does not support NLSP. RIP/SAP controls the communication.
You can select the routing protocol from a) NLSP with RIP/SAP Compatibility, or b)
RIP/SAP Only. If you remove the bind of RIP or SAP when NLSP with RIP/SAP
Compatibility is specified, the network interface then cannot communicate with the file
server and NDS. (See "Protocols" and "Bindings" in NetWare's INETCFG utility.)
Bindery and NDS
❏ You can check the bindery context path from the server console by using the SET
BINDERY CONTEXT command.
❏ If the bindery context path has not been set, or if you want to use the printing
environment of another context from a non-NDS client, you need to specify the context
for the bindery context. Use the SET BINDERY CONTEXT command to set the context
in the AUTOEXEC.NCF file.
❏ You cannot use the bindery print server mode with EpsonNet Config if you are running
Novell Client for Windows 95/98 version 3.00 or Novell Client for Windows NT version
4.50. To configure the network interface for bindery mode, use Novell IntranetWare
Client or EpsonNet Config with Web Browser.
See your NetWare documentation for more information.
Time required to recognize the network interface
It takes up to two minutes for the NetWare server to recognize the network interface, after
the printer is turned on. During this start-up time, the status sheet does not show the
correct information.
Frame type
The same frame type should be used for the NetWare server and IPX router on the same
network. If more than one frame type is used on the same network, bind all the frame types
to the NetWare servers and IPX routers.
67
How To