Epson EPL-6200 Network Manual page 147

Network Guide
OK button:
Saves the settings.
Cancel button:
Cancels any changes.
Note:
❏ The settings you make above can be changed from the printer driver. In the printer
Properties dialog box, click the Details tab, and click the Port Settings button to change the
settings.
❏ Be aware that when connecting to the Internet using a dial-up router and selecting the Get
status every 20 sec check box, you may be charged for the extra line connection.
❏ When you check the Get Printer Attributes check box and click OK, an error message may
appear. Be sure that the printer power is on, and the printer is correctly connected on the
network.
❏ If the printer power is off or there is a problem on the network, the Get status every 20 sec
check box is automatically cleared. If this happens, make sure that the printer power is on
and the printer is correctly connected on the network, and then select the Get status every
20 sec check box again.
5. Click OK to save settings.
6. When a message appears saying the settings are correctly configured, click OK to start
the Add Printer Wizard. Click Next.
Note:
If you click Cancel and then later want to add the printer, start the Add Printer Wizard and follow
the steps below.
7. Click the Local printer radio button and click Next.
8. Select the printer driver and click Next.
If the following dialog box appears, select Replace existing driver and click Next.
147
Network Software