AGFA ADC Solo User Manual page 15

The display
The ADC Solo control panel has a backlit LCD display with 8 lines of 40 charac-
ters each. Its lay-out depends on the operating mode.
In operator mode, the display has dedicated areas for specific information:
8.1
8.2
8.3
Set-up of image processing station:
1
• [blank]: Default image processing station selected.
• Off line: Transmission to all image processing stations disabled.
• [process.station] not ready: Image processing station not available.
• [process.station] rerouted: Images rerouted to other image processing sta-
tion.
2 Type of message
3 Extra comment or action to take
System status:
4
• READY: The ADC Solo is ready for operation.
• BUSY: The ADC Solo is treating an image plate.
• ERROR: An error has occurred. Refer to
page 50.
• LOCKED: id.
• WARNING: id.
5 Operation mode:
• [blank]: Normal operation mode.
• EMERGENCY: Emergency function for image plates with ID data.
• EMERGENCY BUTTON: Emergency function for image plates without
ID data.
• ERASURE: Re-erasure function.
• DIRECT ID: Operation in dedicated configuration.
Error status: service code (SERVICE XXXXX) or error code (CODE XXXXX)
6
2301D EN 20040224
2
1 1
Set-up
1ST MESSAGE
2nd Message
Patient_Last_Name
Patient_Last_Name
Patient_Last_Name
Station Name
7
3 4
STATUS
OPERATION MODE
Sub_Exam
Sub_Exam
Sub_Exam
ERROR
'Troubleshooting checklist'
5
6
on
15