AGFA ADC Solo User Manual page 18

Emergency buttons
Two emergency buttons are located at the front of the ADC Solo. The emer-
gency buttons determine the speed class, i.e. the sensitivity, which will be used
to digitize the image plate. The sensitivity associated with the emergency but-
tons has been set during the configuration of your system. For more information,
contact your local service organization.
The emergency buttons have the following labels:
In the interchangeable configuration, the emergency buttons permit you to
digitize emergency image plates without ID data.
In the dedicated configuration, the emergency buttons permit you to digitize
an image plate while you are entering the identification data via the ID Station.
Audio signals
The ADC Solo gives status information via beeps. The length of the beep indi-
cates the response of the system to a key command.
• A short beep means that ADC Solo has accepted the key command and is start-
ing the operation.
• A long beep means that you have pressed a non-active key or that the ADC Solo
has rejected the key command.
• An interval beep accompanies an error, locked or warning message. Refer to
'Troubleshooting checklist'
18
For digitizing images of the trunk.
For digitizing images of the limbs.
on page 50.
2301D EN 20040224