3
Insert the cassette containing the image plate into the cassette slot of the ADC
Solo as shown below.
Make sure to insert the cassette with the hinge [1] at the top and the locking mecha-
nism [2] at the bottom.
1
The ADC Solo starts digitizing the image plate. You can enter the identification data,
refer to step 4.
While treating the image plate, the ADC Solo will display the following screen:
IDENTIFY AT ID STATION
or press
ADC SOLO
The ADC Solo converts the information of the latent image to digital data.
If the ADC Solo displays an error message, refer to
operation ('Key-operator
2301D EN 20040224
2
to use emergency data
mode')'.
BUSY
DIRECT ID
Chapter 3, 'Advanced
29