Physical Description - Crestron TPS-G-TPI Operation Manual

®
Crestron Isys TPS-G-TPI
Operations Guide – DOC. 6445
TPS-G-TPI Specifications (continued)
1 The latest software versions can be obtained from the Crestron website. Refer to the NOTE
following these footnotes.
2 Crestron 2-Series control systems include the AV2 and PRO2. Consult the latest Crestron Product
Catalog for a complete list of 2-Series control systems.
3 When loading VT Pro-e files or firmware through the RS-232 port of the control system, be sure that
the baud rate is at 38400 (Cresnet speed) or lower. Otherwise, Toolbox may post the "Transfer
Failed" message.
4 CAUTION: Verify that any compact flash used either contains no files or only contains files you
want loaded to the interface prior to inserting into the interface. When unknown files reside on the
compact flash, existing files on the interface may be overridden or erased if the interface reboots.
5 Although flash memory is expandable to 192MB, the current suggested maximum project size is
170MB or less. Projects larger than this may load without error, but may not display correctly.
6 Refer to the Crestron website or contact Crestron Customer Service for the latest firmware
capabilities and device support.
NOTE: Crestron software and any files on the website are for authorized Crestron
dealers and Crestron Authorized Independent Programmers (CAIP) only. New users
may be required to register to obtain access to certain areas of the site (including the
FTP site).

Physical Description

The electronic hardware is housed in a black metal, single-space (1U), 19-inch rack
mount unit. This unit is designed to allow for the integration of non-Crestron
touchscreens into the Crestron control system. All audio, serial, video, and network
connections are made at the rear of the unit. A power LED and a recessed reset
button are located on the front.
TPS-G-TPI Front View
TPS-G-TPI Rear View
G-Series Touchpanel Interface
®
Isys G-Series Touchpanel Interface: TPS-G-TPI ¥
5