Crestron TPS-G-TPI Operation Manual page 11

®
Crestron Isys TPS-G-TPI
Pin 5
Pin 10
Pin 15
Operations Guide – DOC. 6445
Ports and Pushbuttons
All connections to the TPS-G-TPI interface are made through the ports on the rear
panel. Refer to the illustrations and descriptions that follow.
VGA OUTPUT
Pin 1
A DB15HD female connector is provided for RGB (VGA) output. A touchpanel,
PC monitor or other device would be connected to the VGA OUTPUT for analog
Pin 6
video.
Output DB15HD Pinout
Pin 11
PIN DESCRIPTION
1 Red video output
2 Green video output
3 Blue video output
4 Not Connected
5 GND
6 GND
7 GND
8 GND
PHONE
Connect this standard mini phone jack (12 mW, 32 ohm load) to the plug of a 3.5
mm external plug (not supplied) for either a pair of external amplified speakers or
headphones.
RS-232
This 6-pin RJ-11 connector mates with a 9-pin serial port of a PC. The connecting
cable is not supplied. Use this port to establish a direct connection between the
TPS-G-TPI and a PC, mouse or touchscreen input. When a direct connection to a PC
is established, firmware updates and other files can be uploaded to the TPS-G-TPI.
Additionally, the interface's diagnostic tools and set up screens can be accessed over
the direct connection or a direct connection to a touchpanel. In the event that modular
cables or an RJ-11 to DB9F adapter is not available, the following table and diagram
provide information so that the cable can be fabricated on site. Refer to "RS-232
Menu" on page 18 for RS-232 port configuration settings.
RS-232 Pinouts
PIN # DESCRIPTION
1
2
3
4
5
6 N/C (Not connected)
G-Series Touchpanel Interface
PIN DESCRIPTION
9 Not Connected
10 GND
11 Not Connected
12 Not Connected
13 Horizontal or Composite Sync
14 Vertical Sync
15 Not Connected
1
CTS
Top
GND
RXD
TXD
Front
RTS
1
®
Isys G-Series Touchpanel Interface: TPS-G-TPI ¥
6
6
7