Crestron TPS-G-TPI Operation Manual page 40

G-Series Touchpanel Interface
®
36 ¥ Isys G-Series Touchpanel Interface: TPS-G-TPI
C2Net Device, Slot 9
Setting the Net ID in Device Settings
Double-click the TPS-G-TPI icon in the upper pane to open the "Device Settings"
window. This window displays TPS-G-TPI device information. If necessary, select
the Net ID tab to change the Net ID, as shown in the following figure.
"Device Settings" Window for the TPS-G-TPI
NOTE: This procedure sets the Net ID for the TPS-G-TPI interface in the program
only. It does not automatically set the Net ID for the interface itself. SIMPL
Windows automatically changes Net ID values of a device added to a program if a
duplicate device or a device with the same Net ID already exists in the program.
Always ensure that the hardware and software settings of the Net ID match. For Net
ID hardware settings details, refer to "Interface Menu" which begins on page 16.
TPS-G-TPI Symbol in Programming Manager
Programming Manager is where programmers "program" a Crestron control system
by assigning signals to symbols. The symbol can be viewed by double clicking on
the icon or dragging it into Detail View. A description for each signal in the symbol
is described in the SIMPL Windows help file (F1).
®
Crestron Isys TPS-G-TPI
Operations Guide – DOC. 6445