Industry Compliance; Setup; Network Wiring - Crestron TPS-G-TPI Operation Manual

®
Crestron Isys TPS-G-TPI

Setup

Operations Guide – DOC. 6445
Pushbuttons
There is only a single, recessed button on the front panel of the TPS-G-TPI interface.
It is the hard reset used to reboot the interface.
TPS-G-TPI Pushbuttons
HARD RESET
BUTTON

Industry Compliance

As of the date of manufacture, the TPS-G-TPI, has been tested and found to comply
with specifications for CE marking and standards per EMC and Radio
communications Compliance Labeling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.

Network Wiring

CAUTION: In order to ensure optimum performance over the full range of your
installation topology, Crestron Certified Wire, and only Crestron Certified Wire, may
be used. Failure to do so may incur additional charges if support is required to
identify performance deficiencies as a result of using improper wire.
CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to
do so could cause equipment damage or void the Crestron warranty.
CAUTION: Provide sufficient power to the system. Insufficient power can lead to
unpredictable results or damage to the equipment. Please use the Crestron Power
Calculator to help calculate how much power is needed for the system
(http://www.crestron.com/calculators).
When calculating the length of wire for a particular Cresnet run, the wire gauge and
the Cresnet power usage of each network unit to be connected must be taken into
consideration. Use Crestron Certified Wire only. If Cresnet units are to be daisy-
chained on the run, the Cresnet power usage of each network unit to be daisy-
chained must be added together to determine the Cresnet power usage of the entire
chain. If the unit is a home-run from a Crestron system power supply network port,
the Cresnet power usage of that unit is the Cresnet power usage of the entire run. The
G-Series Touchpanel Interface
®
G-Series Touchpanel Interface: TPS-G-TPI ¥ 11
Isys