Crestron TPS-G-TPI Operation Manual page 13

®
Crestron Isys TPS-G-TPI
Operations Guide – DOC. 6445
USB
Two Universal Serial Bus (USB) "A" connectors provide a communications link.
USB is a connectivity specification developed by the USB Implementers Forum
that provides a single, simple, standardized way to connect devices to a computer.
USB shielded cables contain two wires for power +5 volts (red) and ground
(brown) and a twisted pair of wires (yellow and blue) that carry data.
USB Type A Connector Pinout
PIN DESCRIPTION
1 +5 VDC
2 Data -
3 Data +
4 Ground
MEMORY EXPANSION
The onboard memory may be enhanced with the addition of a Type II compact flash
memory card (up to 192 MB).
CAUTION: Verify that any compact flash used either contains no files or only
contains files you want loaded to the interface prior to inserting into the interface.
When unknown files reside on the compact flash, existing files on the interface may
be overridden or erased if the interface reboots.
NOTE: Although flash memory is expandable to 192MB, the current suggested
maximum project size is 170MB or less. Projects larger than this may load without
error, but may not display correctly.
The flash memory slot is accessible on the rear panel of the unit and is labeled
MEMORY EXP. Slots A and B are PCMCIA slots and are not currently
supported.
QuickMedia Connections
There are two QM input ports for connecting two QM sources and one QM output
port for connecting a QM receiver or any other device with a QM input. Each QM
port has an RJ-45 connector with pinouts described in the following table. For wiring
information, refer to "QuickMedia Network Wiring" on page 12.
G-Series Touchpanel Interface
NOTE: This connector is reserved for
future applications (i.e., mouse and touch
input).
®
Isys G-Series Touchpanel Interface: TPS-G-TPI ¥
9