Hardware Hookup - Crestron TPS-G-TPI Operation Manual

®
Crestron Isys TPS-G-TPI
Operations Guide – DOC. 6445

Hardware Hookup

Refer to the following diagrams and complete the video and communications
connections as needed in any order. Be sure to connect ground (G) and 24-volt
power prior to connecting other cables.
NOTE: To prevent overheating, do not operate this product in an area that exceeds
the environmental temperature range listed in the table of specifications.
Consideration must be given if installed in a closed or multi-unit rack assembly since
the operating ambient temperature of the rack environment may be greater than the
room ambient. Contact with thermal insulating materials should be avoided on all
sides of the unit. Do not block fan vents.
NOTE: The maximum continuous current from equipment under any external load
conditions shall not exceed a current limit that is suitable for the minimum wire
gauge used in interconnecting cables. The ratings on the connecting unit's supply
input should be considered to prevent overloading the wiring.
NOTE: Sound from the QuickMedia inputs along with WAV and keyclick is sent to
the stereo headphone/line out and QuickMedia output. Mic input received at the
QuickMedia inputs is sent to only the QuickMedia output.
NOTE: Audio, video and QuickMedia connections must use Crestron Certified Wire
(CresCAT-QM, CresCAT-IM) to ensure optimum performance.
NOTE: Crestron recommends an independent power supply for the TPS-G-TPI
when Cresnet power is not available.
Make the required connections as shown and described in the following sections.
Refer to the following illustration for proper connections; apply Cresnet with power
first.
G-Series Touchpanel Interface
®
G-Series Touchpanel Interface: TPS-G-TPI ¥ 31
Isys