Crestron TPS-G-TPI Operation Manual page 12

G-Series Touchpanel Interface
LAN
®
8 ¥ Isys G-Series Touchpanel Interface: TPS-G-TPI
PC to TPS-G-TPI Cable Specifications (Crestron Cable Number STCP-502PC)
LAN
One 8-wire RJ-45 connector with two LED indicators (green LED indicates link
status, yellow LED indicates Ethernet activity). This connector provides an Ethernet
10baseT /100baseTX, full duplex, TCP/IP, UDP/IP, CIP, IEEE 802.3U compliant
network connection.
Network Connector Pinout
PIN SIGNALS
1 TX +
2 TX -
3 RC+
4 N/C
5 N/C
6 RC -
7 N/C
8 N/C
24VDC
One 24 Volt DC power jack (PW-2420RU power supply sold separately) powers
the TPS-G-TPI interface in lieu of Cresnet power.
NET
The four-pin 5 mm detachable terminal block provides communication with and
power from a Cresnet control network. For additional details, refer to "Network
Wiring" on page 11. A cable for this connection is provided with the interface.
Pins 24 and G provide 24 VDC and ground respectively. Power supply CNWPS-75
OR C2N-SPW5300 can be used to power the TPS-G-TPI.
Pins Y and Z provide communications (data).
®
Crestron Isys TPS-G-TPI
Operations Guide – DOC. 6445