Crestron TPS-G-TPI Operation Manual page 51

®
Crestron Isys TPS-G-TPI
Operations Guide – DOC. 6445
pinouts for straight through and crossover RJ-45 cables. Pins 4, 5, 7, and 8
are not used.
RJ-45 Straight Through Cable – For Connection Through Hub
FROM COLOR
PIN
1 White/Orange
2 Orange
3 White/Green
6 Green
RJ-45 Crossover Cable – For Direct PC Connection
FROM COLOR
PIN
1 White/Orange
2 Orange
3 White/Green
6 Green
5. Once the cable connections are made, open Crestron Toolbox and click
Tools | Manage Address book to display the "Address Book" window.
6. Select the interface from the address book or click Add Entry and type a
new name for the new device, such as TPS.
7. Click TCP as the connection type. Enter the IP address or hostname of the
interface and click OK.
"Address Book" Window – TCP/IP Setup
8. Click Tools | System Info to display the "System Info" window. From the
pull-down menu at the lower left of the window, select the entry created in
step 7.
If the interface is to communicate with a control system over TCP/IP, an IP table
must be created on the interface to identify the control system(s) it will communicate
with over TCP/IP.
G-Series Touchpanel Interface
SIGNAL TO PIN
Tx+ 1
Tx- 2
Rc+ 3
Rc- 6
SIGNAL TO PIN
Rc+ 3
Rc- 6
Tx+ 1
Tx- 2
®
G-Series Touchpanel Interface: TPS-G-TPI ¥ 47
Isys
SIGNAL
Tx+
Tx-
Rc+
Rc-
SIGNAL
Tx+
Tx-
Rc+
Rc-