Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual page 97

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
12. At the back of the display module, on the button board detach
both sides of the ribbon harness (see Figure 172).
13. Use a deep socket with extension to remove the five nuts off of
their respective standoffs (see Figure 172).
Figure 172: Oven Display Module (Back Side Shown)
1 Standoffs with nuts (5)
2 Screw locations (2) holding display module bracket
onto control panel
3 Ribbon harness (with connector at each side)
14. Gently lift the button board off of the standoffs to remove it (see
Figure 173). The LCD board is located underneath, and is still
attached to the standoffs (see Figure 174).
15. At the LCD board, remove the sleeve from each of the five
standoffs, and then gently lift the LCD board off of the standoffs
(see Figure 174 and Figure 175 on page 99).
58300000163852_ARA_EN_C
Figure 173: Removing the Button Board
Figure 174: LCD Board (Back Side Shown)
1 Sleeves on standoffs (5)
2 LCD board
Page 98 of 123