Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual page 44

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
3. Rotate the oven light switch bezel counter-clockwise to remove it
(see Figure 60).
HINT: If the bezel does not rotate easily by hand, use a wrench
with protective cloth to avoid scratching, or a strap wrench.
Figure 60: Light Switch Bezel & Screws at Bottom of Control Panel
1 Light switch bezel
2 Screw for display module
3 Screw for display module
4. At the back side of the control panel, pull out the light switch.
Leave its two spade connectors attached unless you are going to
replace the light switch. See Figure 61.
5. Replace the oven light switch if needed by detaching the wire
connectors.
58300000163852_ARA_EN_C
6. [If only replacing the button guide]: The button guide can be
removed without removing the display module from the control
panel. From the back of the control panel, use a small screwdriver
to press lightly on the four black standoffs located at the back of
the button board (see Figure 59, page 44 and Figure 67, page 47),
and then pull the button guide out from the front of the control
panel.
Figure 61: Steam Oven Light Switch
7. [If removing the display module from the control panel]: On
the bottom side of the control panel under the display, remove and
retain the two screws (see Figure 60).
8. At the back of the control panel, detach the multi-pin wire
connector from the display module (see Figure 59, page 44).
9. At the back of the control panel, detach the two wire connectors
from the display module by gently sliding them off (see Figure 59,
page 44
10. Remove the display module by pulling it over the manifold (see
Figure 61).
Page 45 of 123