Broil Element Components - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
12. Pull the bracket and motor forward slightly (into the cavity). See
Figure 203.
Figure 203: Removing the Motor and Bracket
13. Remove and retain the three screws holding the bracket onto the
motor, and then detach the wire connectors from the motor
terminals (see Figure 204).
Figure 204: Removing the Bracket from the Motor
58300000163852_ARA_EN_C
6.11.7 Broil Element Components – Removal and Replacement
This procedure requires access from the front of the range for
replacing the element and broil reflector plate. Broil flue pipe
replacement requires access from the top and front of the range.
Be sure to check QuickFinder for relevant information, documentation,
and correct part numbers when replacing any of these components.
Hot Surfaces
The oven broil components and interior surfaces of the oven may be
hot and can cause burns. Do not service the range when these
components are hot.
Eye Protection
To protect your eyes from debris, it is recommended to wear
protective eye wear at all times when removing or installing
components inside the oven cavity.
Figure 205: Broil Reflector Plate
Page 114 of 123