Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual page 50

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
7. [To remove the element]: (The fan can remain in place.) From
the back of the range, detach the two convection element wire
connectors and then remove and retain the nuts from the two
element standoffs (see Figure 73).
8. From the front of the range, inside the steam oven cavity, remove
the element (see Figure 72, page 50), and replace it if needed.
Figure 73: Convection Element Components at Back of Range
1 Nut (on element standoff)
2 Convection motor
3 Wire connectors (2) for convection motor
4 Nut (on element standoff)
5 Wire connectors (2) for convection element
58300000163852_ARA_EN_C
9. [To remove the motor]: After you have removed the fan and
shim ring (the element can remain in place), from the back of the
range, detach the two motor wire connectors (see Figure 73).
10. From the back of the range, use a flat blade screwdriver to pry the
motor out of the groove on the cavity (see Figure 74), then pull the
motor out.
Figure 74: Detaching the Convection Motor
11. Replace the motor if needed.
NOTE: When installing the motor, the two spade wire connectors
can be connected to either of the two motor terminals.
Page 51 of 123