Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual page 45

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
Figure 62: Removing Display Module from Back of Control Panel
Figure 63: Display Module (Front Side Shown with Button Guide
Attached)
58300000163852_ARA_EN_C
11. Replace display module if necessary, or perform the following
steps for the removal and replacement of individual components.
12. At the back of the display module, on the button board detach
both sides of the ribbon connector (see Figure 64).
13. Use a deep socket with extension to remove the five nuts off of
their respective standoffs (see Figure 64).
14. Gently lift the button board off of the standoffs to remove it (see
Figure 64). The LCD board is located underneath, and is still
attached to the standoffs (see Figure 65, page 47).
Figure 64: Display Module (Back Side Shown)
1 Standoffs with nuts (5)
2 Ribbon connector (detach both sides)
Page 46 of 123