Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual page 103

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
Figure 184: Another Typical Cooling Fan (View from Under the
Mounting Bracket)
1 Screw locations (4) securing bracket onto the range.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Remove the backguard, per Backguard Removal and
Replacement procedure, page 100.
3. At the back of the range, detach the cooling fan wire connectors,
and make a note of which wires are connected to each of the two
different terminals.
NOTE: It is always recommended to label and tag all wires, wire
connectors and harnesses prior to disconnecting them, so as to
correctly identify their connections/locations when reassembling.
Alternatively, you can photograph the wire connections prior to
disconnecting (for example, with your mobile phone).
58300000163852_ARA_EN_C
4. Remove and retain the screws that secure the cooling fan
mounting bracket onto the range chassis (see Figure 183
and Figure 184).
NOTE: For some cooling fans, to remove the screws from the
bracket, from under the maintop, insert the screwdriver through
the access holes on the chassis (see Figure 185).
5. Using gloves, remove the cooling fan.
6. Replace the cooling fan if needed.
Figure 185: Using Access Holes for Removing Fan Screws
1 Screwdriver (shown through access hole)
Page 104 of 123