Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual page 64

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
7. At the base of the steam oven back panel, remove and retain the
eight screws, then remove the bracket (Figure 103 & Figure 104).
Figure 103: Removing Bracket under Steam Oven Back Panel
1 Screws on bracket (upper part shown)
Figure 104: Bracket and Screw Locations
1 Screws (4) on upper part of bracket
2 Screws (4) on lower part of bracket
58300000163852_ARA_EN_C
8. Remove the back panel for the steam oven (see Back Panel for
Steam Oven – Removal and Replacement, page 102).
9. Remove and retain the screw holding the retaining bracket (see
Figure 105).
10. Detach the warming drawer wire connector. You may have to pull
the wire harness out a bit if it is covered by insulation (see
Figure 105).
Figure 105: Removing Retaining Bracket and Detaching Wire
Connector
1 Screw (1) on retaining bracket
2 Wire connector location
Page 65 of 123