Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual page 28

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
Figure 23: Removing Gas Tube from Jet Holder Assembly
6. Make note of which way the burner support rails are placed on the
range chassis before removing, so you can reinstall in the correct
position in relation to the jet holder assemblies and gas tubes.
Sharp Component – Gloves Recommended
The burner support rail has sharp edges. Avoid injury by using gloves
when removing or installing burner support rails.
Gas Leaks
With electrical power off, carefully check for gas leaks at each gas
component that was removed, replaced, or otherwise serviced using a
gas leak detector or bubble test.
7. Use a large flat-blade screwdriver to push one side of the burner
support rail to the other side of the chassis, until the 2 prongs
58300000163852_ARA_EN_C
come out from their slots on the chassis (see Figure 24). Then
remove burner support rail with the two jet holder assemblies
attached (see Figure 25).
Figure 24: Removing Burner Support Rail from Range Chassis
Figure 25: Burner Support Rail with Jet Holder Assembly Attached
Page 29 of 123