Configuring Pri2 Data Block For System Timers Using Ld 73 - Avaya Communication Server 1000 Installation And Commissioning Manual

Use

Configuring PRI2 data block for system timers using LD 73

2 Mb/s PRI2 data block including system timers.
Configuring PRI2 data block for system timers using LD 73
1. Log on to the CS 1000E.
2. To access LD 73, enter:
3. Enter the responses shown in
Media Gateway 1000E PRI Gateway Installation and Commissioning
Prompt Response
- SREF Card
... ...
TRSH 0 - 15
RALM 1–(3)–128
... ...
LD 73
timers (LD 73) on page 93.
Table 25: Configuration for PRI2 data block system timers (LD 73)
Prompt Response
REQ aaa
TYPE PRI2
FEAT SYTI
... ...
MGCLK sl s c
- PREF Card
- SREF Card
Configure E1/T1 ports on a Call Server
Description
Card number of PRI containing the Secondary
Clock Reference for the second IPMG.
To modify, use the CHG command (you can
change the PREF only if you change the
MGCLK).
Create or change a PRI threshold set.
Enter this number in LD 17 when defining the PRI
loop.
Yellow alarm (remote alarm) 24-hour threshold.
Number of remote alarm clear signals received in
24 hours.
Table 25: Configuration for PRI2 data block system
Description
Request (aaa = CHG, END, NEW, OUT, or
PRT).
DTI2 and JDMI are not supported for MGP.
Feature = SYTI (System Timers)
Superloop, shelf, card number of PRI2 containing
the Primary Clock Reference for the first IPMG.
The card number (1 - 8) should match the span
number configured through the Web interface.
Card number of PRI2 containing the Primary
Clock Reference for the first IPMG.
Card number of PRI2 containing the Secondary
Clock Reference for the first IPMG.
on page 93 to configure the
March 2013 93