Enable Pri Spans - Avaya Communication Server 1000 Installation And Commissioning Manual

Enable PRI spans

For every span on the E1/T1 card, enable the NTBK51AA/NTBK51AAE5/NTBK51CAE5 card
(and later) or the NTAK93AB daughterboard and enable the clock controller.
If you use the NTBK51AA/NTBK51AAE5/NTBK51CAE5 (and later) daughterboard, follow the
procedure described in
daughterboard
If you use the NTAK93AB daughterboard, follow the procedure described in
NTAK93AB daughterboard
software.
To enable the clock controller, follow the procedure described in
controller on page 102.
Enabling the NTBK51AA/NTBK51AAE5/NTBK51CAE5 daughterboard
1. In LD 60, enter the command to enable all 1.5/2.0 Mb PRI loops through the
Media Gateway 1000E PRI Gateway Installation and Commissioning
Prompt Response
... ...
DDSL 0 - 15
SIGL DPN/DAS
CUST xx
NCOS (0) - 99
... ...
RTMB 0-511 1-4000
... ...
TGAR 0 - (1) - 31
... ...
CLS aaaa
... ...
Enabling the NTBK51AA/NTBK51AAE5/NTBK51CAE5
on page 101 to enable the PRI spans through software.
on page 102 to enable the DPNSS/DASS spans through
software:
Description
DASS2/DPNSS D-channel logical port number,
entered in LD 74.
DPN = DPNSS signaling
DAS = DASS signaling
Customer number, as defined in LD 15.
Network Class of Service group.
Route number and member number.
Range is the same as that for CS 1000E
system.
Trunk Group Access Restriction. The default "1"
automatically blocks direct access.
Class of Service.
Enable PRI spans
Enabling the
Enabling the clock
March 2013 101