Configure Basic System Parameters - Avaya Communication Server 1000 Installation And Commissioning Manual

Configure an E1/T1 card
3. Enter the new password in the New password field and enter it again in the Confirm
4. Click Submit.

Configure basic system parameters

The administrator completes the basic parameters for the E1/T1 card. See
parameters for an E1/T1 card through the Web
Configuring basic parameters for an E1/T1 card through the Web
1. On the Home - System Overview screen, select System Settings > Basic
2. In the MGC IP address field, type the IP address of the Media Gateway
3. In the System Name field, type up to 15 alphanumeric characters for the name of
4. In the IP address of E-mail Server field, type the IP address.
114 Media Gateway 1000E PRI Gateway Installation and Commissioning
new password field.
Setting.
The window shown in
page 114 appears.
Figure 31: System Settings - Basic Settings window
The IP address was previously defined through a CLI command as shown in
Configure LAN parameters
Controller.
The E1/T1 card uses this address to receive the time and date from the Media
Gateway Controller.
the system.
The E1/T1 card uses this address to send system backup files. If this field is left
empty or is incorrect, the E1/T1 card does not send e-mail messages. However, the
rest of the system operates properly.
Comments? infodev@avaya.com
on page 114.
Figure 31: System Settings - Basic Settings window
on page 105.
Configuring basic
on
March 2013