Configuring The Pri2 Loop Timers Using Ld 73 - Avaya Communication Server 1000 Installation And Commissioning Manual

Configure an E1/T1 card
Use

Configuring the PRI2 loop timers using LD 73

timers and thresholds.
Configuring the PRI2 loop timers using LD 73
1. Log on to the CS 1000E.
2. To access LD 73, enter:
3. Enter the responses shown in
94 Media Gateway 1000E PRI Gateway Installation and Commissioning
Prompt Response
MGCLK sl s c
- PREF Card
- SREF Card
... ...
LD 73
page 94.
Table 26: PRI2 loop timers and thresholds (LD 73)
Prompt Response
REQ aaa
TYPE PRI2
FEAT LPTI
LOOP loop
MFF aaa
ACRC (NO) YES
ALRM aaa
RAIE (NO) YES
Comments? infodev@avaya.com
Description
To modify, use the CHG command (you can
change the PREF only if you change the
MGCLK).
Superloop, shelf, card number of PRI2 containing
the Primary Clock Reference for the second
IPMG.
The card number (1 - 8) should match the span
number configured through the Web interface.
Clock Reference for the second IPMG.
Card number of PRI2 containing the Secondary
Clock Reference for the second IPMG.
To modify, use the CHG command (the PREF
cannot be changed unless the MGCLK is
changed).
on page 94 to configure the PRI2 loop
Table 26: PRI2 loop timers and thresholds (LD 73)
Description
Request (aaa = CHG, END, NEW, OUT, or
PRT).
DTI2 and JDMI are not supported for the PRI
Gateway.
Feature = SYTI (System Timers).
Loop number for PRI2.
Multiframe format (aaa = AFF or CRC).
Automatic reporting of CRC-4 error.
Default alarm handler selected (aaa = REG or
ALT).
RAIE Group II alarm state enabled or disabled.
on
March 2013