Avaya Communication Server 1000 Installation And Commissioning Manual page 123

2. To test all PRIs, enter:
3. To enable all configured PRIs, enter:
4. To enable the NTBK51AA/NTBK51AAE5/NTBK51CAE5 (and later) DDCH
5. To enable the D-channels, enter:
6. Perform a status check as shown in
Use the steps in
normally. This check assumes that the PRI and DDCH daughterboards are properly installed
Media Gateway 1000E PRI Gateway Installation and Commissioning
In Figure 33: PRI startup
the red LED is lit.)
Figure 33: PRI startup
LD 60
DISL loop
SLFT loop
The response is:
SLFT OK.
LD 60
ENLL loop
The PRI loop is now up, the remote alarm is cleared, and the D-channel is
disabled.
daughterboard, enter:
LD 96
ENL MSDL sl s c
The DDCH card is downloaded and enabled. The D-channel is disabled.
LD 96
ENL DCH X
If the D-channel is established, the response is:
DCH EST time and date
If you do not get the DCH EST time and date response, enter EST DCH x.
Checking PRI status
on page 123, the PRI shown is disabled. (For the DCH,
Checking PRI status
on page 124 to verify that a PRI/PRI2 is working
PRI startup
on page 124.
March 2013 123