Configuring Pri2 Trunk Routes Using Ld 16 - Avaya Communication Server 1000 Installation And Commissioning Manual

Configure an E1/T1 card

Configuring PRI2 trunk routes using LD 16

Data Block data required for PRI2/E1 trunks. The example given in
16) on page 96 is specific to the EURO interface, however, the PRI trunk route is also
supported on other PRI2 interface types.
Configuring PRI2 trunk routes using LD 16
1. Log on to the CS 1000E.
2. To access LD 16, enter:
3. Enter the responses shown in
96 Media Gateway 1000E PRI Gateway Installation and Commissioning
Prompt Response
... ...
ICOG xx
SRCH (LIN) RRB
ACOD xxx..x
TARG 0-(1)-31
... ...
LD 16
Table 28: PRI2 route (LD 16)
Prompt Response
REQ aaa
TYPE RDB
CUST xx
ROUT 0 - 511
... ...
TKTP xx
DTRK YES
DGTP PRI2
IFC EURO
CNTY aaaa
... ...
ISDN YES
MODE PRA
Comments? infodev@avaya.com
Description
Either incoming, outgoing, or both way trunks.
Search method for outgoing trunk member.
One seven-digit access code for the trunk route.
Trunk Access Restriction Group Number.
on page 96 describes how to configure Route
Table 28: PRI2 route (LD 16)
Description
Request (aaa = CHG, NEW)
Route Data Block.
Customer number, as defined in LD 15.
Route number. Range the same as for Large
System and CS 1000E system.
Trunk type.
Digital trunk route.
Select a digital trunk type of 2.0 Mb/s PRI.
Euro ISDN interface type.
Country.
Integrated Services Digital Network.
ISA route for ISDN PRA. (ISL mode is not
supported in the PRI Gateway.)
Table 28: PRI2 route (LD
on page 96.
March 2013