Chapter 14: Configure An E1/T1 Card - Avaya Communication Server 1000 Installation And Commissioning Manual

Chapter 14: Configure an E1/T1 card

This chapter contains information about the following topics and the tasks to configure an E1/T1 card as
shown in the following table.
Section
Configure E1/T1 ports on a Call
Server on page 82
Media Gateway 1000E PRI Gateway Installation and Commissioning
Related procedures
• Configuring PRI loops using LD 17
• Configuring PRI2 loops using LD 17
• Configuring DPNSS/DASS loops using LD 17
84
• Configuring a D-channel interface to support PRI/NI2 using
LD 17 on page 86
• Configuring a D-channel interface to support PRI2/EURO D-
channels using LD 17
• Configuring DPNSS/DASS D-channels in the PRI Gateway
using LD 17 on page 88
• Configuring DPNSS/DASS D-channel interface using LD
74 on page 91
• Configuring a digital data block using LD 73
• Configuring PRI2 data block for system timers using LD
73 on page 93
• Configuring the PRI2 loop timers using LD 73
• Configuring PRI trunk routes using LD 16
• Configuring PRI2 trunk routes using LD 16
• Configuring DPNSS/DASS trunk routes using LD 16
page 97
• Configuring PRI and PRI2 trunks with Trunk Data Block data
using LD 14 on page 98
• Reconfiguring existing Dchannels on an NTBK51AA/
NTBK51AAE5/NTBK51CAE5 (and later)
• Changing the protocol on an established D-channel using
Element Manager on page 99
• Configuring the DPNSS/DASS trunks with Trunk Data Block
data using LD 14 on page 100
on page 83
on page 84
on page 87
on page 92
on page 95
on page 96
on page 99
on page
on page 94
on
March 2013 81