3. Enter the responses shown in
Configure the Media Gateway Controller
The MGC command line can be accessed using the NTBK48AA three-port SDI cable. A null
modem adapter is used to connect to the MGC serial port.
Enter the following information:
• The ELAN configuration of the IPMG:
- IP address
- subnet mask
Media Gateway 1000E PRI Gateway Installation and Commissioning
LD 17
configuration (LD 17)
Table 14: Media Gateway tone and Conference configuration (LD 17)
Prompt
Response
REQ
CHG
TYPE
CFN
CEQU
YES
...
MGTDS
aaa bbb
IPMG
supl sh
MGCONF
aaa bbb ccc
ddd
IPMG
supl sh
Table 14: Media Gateway tone and Conference
on page 71.
Configuration record.
Common equipment.
Allows the configuration of two Media
Gateway TDS loops simultaneously.
aaa = loop, bbb = 0–255, X to delete the loop
Superloop and shelf of IPMG on which this
MGTDS are associated. No default value is
assigned if the IPMG is not associated. This
prompt allows for the association of the
MGTDS with a particular IPMG.
supl = IPMG superloop, sh = IPMG shelf
Allow the configuration of up to four Media
Gateway conference loops simultaneously.
aaa = loop, bbb = 0–255, X to delete the loop
Superloop and shelf of IPMG on which this
MGTDS are associated. No default value is
assigned if IPMG is not associated. This
prompt allows for the association of the
MGTDS with a particular IPMG.
supl = IPMG superloop, sh = IPMG shelf
Configure the Media Gateway Controller
Description
March 2013
71