Procedure
1. Log on to ACLI to enter User EXEC mode.
2. Enter the show ip vrrp interface command.
3. Observe and note the interface VRRP Admin State .
Result
For a virtual router to be operational on an interface, the VRRP administration state must be UP.
Creating a virtual router
Create a virtual router for a specific interface.
Procedure
1. Enter VLAN Interface Configuration mode:
enable
configure terminal
interface vlan <1–4094>
2. Enter the ip vrrp address <1-255> <A.B.C.D> command.
Enabling a virtual router
Enable virtual router for a specific interface.
Procedure
1. Enter VLAN Interface Configuration mode:
enable
configure terminal
interface vlan <1–4094>
2. Enter the ip vrrp <1-255> enable command.
Next steps
Repeat the Checking interface virtual router status procedure to verify that the virtual router is
active.
Multiple VRRP master routers in a VLAN
This section describes the troubleshooting process you can use to diagnose and resolve a situation
where more than one master virtual router is present within a VLAN.
July 2015
Comments on this document? infodev@avaya.com
Multiple VRRP master routers in a VLAN
Troubleshooting Avaya VSP 7000 Series
93