Viewing Sfp Ddi Information; Job Aid - Avaya Virtual Services Platform 7000 Series Troubleshooting Manual

Viewing SFP DDI information

Use the following procedure to view SFP DDI information.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
show interfaces gbic-info
Example
The following example shows sample output from the show interfaces gbic-info command.
7024XLS>enable
7024XLS#configure terminal
7024XLS(config)#show interfaces gbic-info
Port Number
GBIC Type
Wavelength
Vendor Name
Vendor OUI
Vendor Part #
Vendor Revision
Vendor Serial
HW Options
Date Code
CLEI Code
Product Code
Digital Diagnostic Interface supported
Calibration: Internal
Rx Power Measurement: Average
-------------------------------------------------------------------------------
LOW_ALARM
THRESHOLD
-------------------------------------------------------------------------------
Temp(C) -5.000
Voltage(V) 2.9700
Bias(mA) 2.000
TxPower(dBm) -9.5000
RxPower(dBm) -13.0102

Job aid

The following table describes output for the show interfaces gbic-info command.
July 2015
3
SX
850 nm
AVAYA
00176A
AFBR-5715PZ-NT1
N/A
AVAGCNAS00FV1
TX_DISABLE TX_FAULT RX_LOSS
10/01/2011
IPUIAHCWAA
AA1419048-E6
LOW_WARN ACTUAL
THRESHOLD VALUE
0.000 29.468
3.0200 3.2934
3.000 8.216
-8.9997 -5.2374
-11.9997 -7.3376
Comments on this document? infodev@avaya.com
HIGH_WARN HIGH_ALARM
THRESHOLD THRESHOLD
90.000 95.000
3.5800 3.6300
15.000 16.000
-1.9997 -1.0001
-1.0001 0.0000
Troubleshooting Avaya VSP 7000 Series
Viewing SFP DDI information
STATUS
NORMAL
NORMAL
NORMAL
NORMAL
NORMAL
47