Ecmp Maximum Path For Rip - Avaya Virtual Services Platform 7000 Series Troubleshooting Manual

Troubleshooting Layer 3
Checking RIP interface supply and listen status
Determine if RIP interfaces are enabled for supplying and listening for RIP advertisements.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. Enter the show ip rip interface command.
3. Observe and note the Supply and Listen status for RIP–enabled interfaces.
Enabling RIP interface supply and listen
Enable RIP supply and listen for VLANs and Ethernet interfaces.
Procedure
1. Enter Interface Configuration mode:
enable
configure terminal
interface Ethernet <port> or interface vlan <1–4094>
2. Enter the ip rip supply enable command to enable RIP supply.
3. Enter the ip rip listen enable command to enable RIP listen.

ECMP maximum path for RIP

Ensure the ECMP maximum path value for RIP is greater than 1.
If the maximum number of ECMP paths for use by RIP is set to 1, only one RIP route is added into
routing table for a reachable destination.
Checking the ECMP maximum path setting for RIP
Display and observe the ECMP maximum path setting for RIP.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. Enter the show ecmp command.
3. Observe and note the maximum path value for RIP.
Configuring ECMP maximum paths for RIP
Ensure the maximum number of ECMP paths for use by RIP is set to a value greater than 1.
Procedure
1. Enter Global Configuration mode:
Troubleshooting Avaya VSP 7000 Series
88
Comments on this document? infodev@avaya.com
July 2015