Chapter 11: Troubleshooting Rstp Snmp Traps; Viewing The Rstp Configuration; Verifying Rstp Traps Are Enabled - Avaya Virtual Services Platform 7000 Series Troubleshooting Manual

Chapter 11: Troubleshooting RSTP SNMP
This chapter describes the troubleshooting process you can use when Simple Network Management
Protocol (SNMP) traps are not generated for Rapid Spanning Tree Protocol (RSTP).
For detailed information about SNMP trap support, see Configuring Security on Avaya Virtual
Services Platform 7000 Series, NN47202–501.
For detailed information about RSTP, see Configuring Layer 2 on Avaya Virtual Services Platform
7000 Series, NN47202–502.

Viewing the RSTP configuration

Use this procedure to view and analyze the switch RSTP configuration.
Before you begin
Select rstp as the STP operating mode.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. Use the show spanning-tree rstp config command to display the RSTP
configuration.
3. Observe and analyze the command output display.

Verifying RSTP traps are enabled

Use this procedure to verify that SNMP trap notification control is enabled for RSTP.
Before you begin
Select rstp as the STP operating mode.
Procedure
1. Enter Global Configuration mode:
July 2015
traps
Comments on this document? infodev@avaya.com
Troubleshooting Avaya VSP 7000 Series
61