Replacing Ac Power Supply Cables On The Jsa Appliance; Replacing A Dc Power Supply On The Jsa Appliance | 112 - Juniper JSA7500 Secure Analytics Hardware Manual

6. Using both hands, slide the replacement power supply straight into the chassis until the power supply
is fully seated in the chassis slot. Make sure the tab on the left edge of the power supply clicks into
place.
7. Attach the power cord to the power supply. If the power supply is correctly installed and functioning
normally, the power supply powers up immediately.
RELATED DOCUMENTATION
Field-Replaceable Units on the JSA Appliance | 105
Replacing the Fan on the JSA Appliance | 106
Replacing the Air Filter on the JSA7500 Appliance | 109

Replacing AC Power Supply Cables on the JSA Appliance | 111

Replacing a DC Power Supply on the JSA Appliance | 112

Replacing DC Power Supply Cables on the JSA Appliance | 113

Replacing AC Power Supply Cables on the JSA Appliance

To replace an AC power supply cord:
1. Unplug the power cord from the power source receptacle.
2. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on
the chassis.
3. Unplug the power cord from the appliance inlet on the power supply.
4. Locate a replacement power cord with the type of plug appropriate for your geographical location.
5. Insert the power cord plug into an external AC power source receptacle.
6. Connect the power cord to the power supply.
7. Verify that the power cord does not block the air exhaust and access to device components, or drape
where people could trip on it.
8. If the power supply is correctly installed and functioning normally, the supply automatically powers
up.
RELATED DOCUMENTATION
Field-Replaceable Units on the JSA Appliance | 105
Replacing the Fan on the JSA Appliance | 106
111