Replacing DC Power Supply Cables on the JSA Appliance
To replace a DC power supply cable connected to a JSA appliance:
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on
the chassis.
2. Switch off the external circuit breakers for all the cables attached to the power supply. Make sure
that the voltage across the DC power source cable leads is 0 V and that there is no chance that the
cables might become active during the removal process.
3. Remove the clear plastic cover over the terminal studs on the faceplate.
4. Remove the power cable from the DC power source.
NOTE: Ensure the cable is not touching or in the way of any components, and that it does not
drape where people could trip on it.
5. Attach the power cable to the DC power source. For more information, see
a DC Power Source" on page
6. Replace the clear plastic cover over the terminal studs on the faceplate.
7. If the power supply is correctly installed and functioning normally, the supply automatically powers
up.
RELATED DOCUMENTATION
Field-Replaceable Units on the JSA Appliance | 105
Replacing the Fan on the JSA Appliance | 106
Replacing the Air Filter on the JSA7500 Appliance | 109
Replacing an AC Power Supply on the JSA Appliance | 110
Replacing AC Power Supply Cables on the JSA Appliance | 111
Replacing a DC Power Supply on the JSA Appliance | 112
Connecting JSA7500 to a DC Power Source | 80
80.
"Connecting JSA7500 to
113