Exhaust Restrictor
Depending upon the vent configuration, the exhaust restrictor may need to be installed (see vent
configurations for details).
If the restrictor is required, install it into the firebox roof as shown below. The restrictor is shipped pre-
assembled in position # 1
.
To adjust the restrictor to a different position, loosen the 4 screws holding the adjuster plates in place.
Slide the to the correct notch (each notch is sequential, position # 1 through 5). Tighten the screws to
secure the adjuster plates.
1/4" Nutdriver
© Travis Industries
Installation
(for qualified installers only)
9/22/2021 - 1561
This restrictor is in position #3.
23
4237 EG