Switch Port
The Switch Port command allows you to switch ports. The default port is 01.
Use the Formula - to set Parameters - to create a Command.
Formula:
Command + Control + [Enter]
Parameters:
Command
sw
Control
ixx
Enter
Enter
Switch Port Commands
The available formula for the Switch Port command is as follows:
1. Command + Control + [Enter]
For example, to switch to port 2, type the following:
sw i02 [Enter]
Note: The Control command can be skipped and the default value will be
used.
Description
Switch Port Command
Description
Input Port Number
xx= 01~08 (CS19208); 01~16 (CS19216)
Description
Enter and send out command
Chapter 7. RS-232 Operation
67