ATEN CS19208 User Manual page 17

No. Component
1 Port Selection
Pushbuttons
2 Port LEDs
3 Firmware
Upgrade
Recovery
Switch
4 Audio Jack
5 Firmware
Upgrade Port
For manual port selection (see Port Selection, page 26, also):

Press a port selection pushbutton for less than two seconds
to bring the KVM, USB hub, and audio focus to the computer
attached to its corresponding port.

Press a pushbutton for longer than two seconds to bring the
KVM and audio focus* to the computer attached to its corre-
sponding port.

Press pushbuttons 1 and 2 simultaneously for 2 seconds to
perform a keyboard and mouse reset start. See Keyboard /
Mouse Reset, page 50, for details.

Press pushbuttons 7 and 8 simultaneously for 2 seconds to
start Auto Scan Mode*. See Auto Scan Mode, page 48, also
Note: Enable mouse emulation for independent switching (see
page 40).
The Port LEDs are built into the Port Selection Switches. The
left ones are the KVM Port LEDs; the right ones are the USB
LEDs:
KVM

Lights DIM ORANGE to indicate that the computer attached
to the corresponding port is up and running (On Line).

Flashes to indicate that Firmware Upgrade mode is in effect.

Changes to BRIGHT ORANGE to indicate that the computer
attached to its corresponding port is the one that has the
KVM focus (Selected).

Flashes to indicate that the computer attached to its corre-
sponding port is being accessed under Auto Scan mode.
USB

Lights GREEN to indicate that the computer attached to its
corresponding port is the one that has access to the USB
peripherals.
During normal operation and while performing a firmware
upgrade, this switch should be in the NORMAL position. If a
firmware upgrade operation does not complete successfully,
this switch is used to perform a firmware upgrade recovery.
See Firmware Upgrade Recovery, page 83, for details.
The cables from your main speakers plug in here.
Note: The speakers plugged in here have priority over those in
the rear panel.
The firmware upgrade cable that transfers the firmware
upgrade data from the administrator's computer to the
CS19208 / CS19216 plugs into this RJ-11 connector.
Description
1. Introduction
7