Open / Close Rs-232 Link - ATEN CS19208 User Manual

Open / Close RS-232 Link

The Open and Close RS-232 Link commands allows you to open/close the link
between the computer sending RS-232 commands and the CS19208 /
CS19216. When the link is open, the CS19208 / CS19216 only accepts RS-232
commands and will not respond to front panel pushbuttons, OSD, hotkeys, and
remote control commands - until the link is closed. The link opens when you
login and closes after 2 minutes if no command is sent.
Use the Formula - to set Parameters - to create a Command.
Formulas:
Command + [Enter]
Parameters:
Command
open
close
Enter
Enter
Open/Close RS-232 Link Commands
The available formulas for the Open/Close RS-232 Link commands are as
follows:
1. Command + [Enter]
For example, to open the RS-232 link between the computer and CS19208 /
CS19216, type the following:
open [Enter]
2. Command + [Enter]
For example, to close the RS-232 link between the computer and CS19208 /
CS19216, type the following:
close [Enter]
Description
Open RS-232 Link command
Close RS-232 Link command
Description
Enter and send out command
Chapter 7. RS-232 Operation
65