Multi-Display Installation; Cable Connections For Multi-Display Installation - ATEN CS19208 User Manual

CS19208 / CS19216 User Manual

Multi-display Installation

The CS19208 / CS19216's multi-display feature allows you to stack two, three,
four, or up to 8 units in a dual/triple/quad-display/multi-display installation to
control up to seven (CS19208) or fifteen (CS19216) computers at once. This
installation requires slightly different cabling than the standard cascade and
offers an extra level of switching flexibility for multiple-monitor installations
where each computer is fitted with multiple video cards.
Note: In a Multi-display installation, the CS19208 can only be connected to
CS19208 units, and the CS19216 can only be connected to CS19216
units.

Cable Connections for Multi-display Installation

To set up your multi-display installation, refer to the installation diagram on the
next page (the numbers in the diagrams correspond to the steps, below), and do
the following:
1. Use a standard USB Type A-to-USB Type B cable to connect the Port 8
USB Type B port on the first stage unit to the USB Type A port in the
Console section of the second switch.
Note:
 Port 8 is reserved to connect the units in a multi-display installation, so
up to seven (CS19208) or fifteen (CS19216) computers can be
attached, using KVM ports 1–7 (CS19208) or ports 1–7/9–16
(CS19216).
 Plug the USB Type-A connector into the lower USB (keybaord) Port in
the Console Port Section (both USB Ports are marked with a similar
icon to remind you of the correct USB port).
2. Use DisplayPort cables to connect the DisplayPort KVM port on the
second CS19208 / CS19216 unit to the second video-in port on the
computers.
Note: Only DisplayPort video cables are necessary – the other ports in the
KVM section are not required in this installation.
3. Connect a display to the console section of the second switch.
4. Repeat steps 1–3 for any additional units, up to a total of 8 switches.
22