ATEN CS19208 User Manual page 30

CS19208 / CS19216 User Manual
6. For each Second Stage unit, plug the power adapter cable into its Power
Jack, then plug the power adapter into an AC source.
7. Plug the First Stage unit's power adapter cable into its Power Jack, then
plug the power adapter into an AC source.
8. Power on the computers.
Note:
 The Power On sequence requires that all Second Stage units be
powered on first. After they are all on, the First Stage units must be
powered on next. Only after all the switches have been powered on in
this sequence, can the computers be powered on.
 The USB 3.1 hub cannot be accessed through the switch by computers
on the second level of a cascaded installation.
 Make sure the computers and devices that the CS19208 / CS19216
connects to are also properly grounded.
20