Table of Contents
Advertisement
TM
Multi-View KVMP
Open/Close RS-232 Link
The Open/Close RS-232 Link command allows you to open/close the link
between the computer sending RS-232 commands and the Multi-View
KVMP
Switch. When the link is "open" the Multi-View KVMP
TM
only accepts RS-232 commands and will not respond to front-panel
pushbuttons, hotkeys, OSD, or remote control signals - until the link is closed.
The link opens when you log in and closes after 30seconds if no command is
sent. To change the timeout settings, configure the Logout Timeout setting in
the OSD Menu (see page 57). Type your command in the following format:
Command + [Enter]
Command
open
close
For example, to open the RS-232 Link between the computer and Multi-View
KVMP
Switch, type the following:
TM
open [Enter]
For example, to close the RS-232 Link between the computer and Multi-View
KVMP
Switch, type the following:
TM
close [Enter]
70
Switch User Manual
Open RS-232 Link Command
Close RS-232 Link Command
Description
Switch
TM
Advertisement
Table of Contents
