3.1. Case of installing two options
Please install this option (CCL001Z1) on the top of options when you install two options.
Do not install under the another option.
3.2. Connection of CC-Link cable
If use other than the CC-Link dedicated cable, the performance of the CC-Link system is
not guaranteed. Please ask a manufacture given in the product catalog of CC-Link
association issue, or the "product information" on a CC-Link association homepage
(http://cc-link.org/) about the details of the CC-Link dedicated cable.
Please use the recommended CC-Link dedicated cable. And strip the cable sheaths and
twist the wires. If the sheath was stripped too long, the cable may contact with the
adjacent cable and cause a short circuit. If the sheath was stripped too short, the cable may
be not connected.
Fix the communication cables after wiring.
*
If take care of the wire end, use below parts.
*
3.3. About a terminal resist change switch(SW6)
By switching SW6 in the left-hand side of a CC-Link teminal, a termination resistor (upper:
110ohms, under: 130ohms) can be switched. A termination resistor will not be connected
if it sets up in the center.
LED name label
POWER
L.RUN
SD
RD
L.ERR
Recommend screwdriver
•
Recommended tightening torque
•
Skin length
•
Manufacture : Phoenix contact corp.
Part Number : AI 0,5-8 WH
Part Number : AI-TWIN2x0,5-8 WH
Length
: 8mm
f)
A small flat-blade screwdriver
:
(tip thickness 0.4mm, full length 2.5mm)
0.22 to 0.25 N・m
:
about 7mm
:
7mm
(connect one wire)
(connect two wires)
- 11 -
E6581476②