Honda HRN216 Series Manual page 81

ENGINE REMOVAL/INSTALLATION
3. VYA TYPE
REMOVAL
1. Drain the gasoline from the fuel tank and carburetor into
an approved container.
2. Remove the throttle cable from the clamp, and
disconnect the cable end from the engine control base.
3. Remove the recoil grip and rope from the handlebar
(P. 11-12).
4. Drain the engine oil
Continue to keep the mower tilted on its right side so the
carburetor is facing up.
5. Remove the blades
gloves to hold the blades with your hand to prevent the
blades from turning, and then remove the two blade bolts
and special washers.
6. Disconnect the Roto-Stop return spring and then
remove the lower end of Roto-Stop cable
5-6
(P. 3-6) and reinstall the oil dipstick.
(P. 4-2). Use a pair of thick leather
(P.
CLAMP
THROTTLE
CLAMP
SCREW
THROTTLE CABLE
LOWER
BLADE
SPECIAL
WASHER (2)
BLADE BOLT (2)
4-2).
CLUTCH SPRING
ROTO-STOP INNER
CABLE
UPPER BLADE
BALL PLATE
HRN216
UPPER
ANCHOR
POINT