Honda HRN216 Series Manual page 74

HRN216
5. Attach the Roto-Stop cable to the ball plate.
6. Wrap the tips of the needle-nose pliers with 1 to 2
rounds of duct tape to prevent damage to the new spring
during installation.
7. Install the clutch spring by lifting the spring hook onto the
upper anchor point using the needle-nose pliers.
Do not clamp or contact the spring coils during installation.
Be careful not to damage or bend the spring.
8. Adjust the blade control lever free play
9. Install the blades, ensuring the curved washers securing the blades are installed correctly
10.Install the recoil starter cover
Check for proper blade control operation
(P. 3-13).
(P. 7-2), and top cover (P.
(P. 3-12).
BLADE HOLDER/ROTO-STOP®
ROTO-STOP INNER
CABLE
CLUTCH SPRING
7-1).
BALL PLATE
UPPER
ANCHOR
POINT
(P. 3-4).
4-13