Honda HRN216 Series Manual page 33

SERVICE INFORMATION
VYA TYPE
Position the cable ties in the locations shown using the handlebar pivot bolts as a
starting point for your measurements. Adjust and tighten the cable ties.
Trim off any remaining tail from each cable tie, and then rotate the cable ties so that the
head and cut edge are facing down.
Left side handlebar:
Loosely install the two upper cable ties around the handlebar, throttle cable, and
Smart Drive cable. Loosely install the lower cable tie only around the throttle cable
and Smart Drive cable.
Right side handlebar:
Loosely install the two upper cable ties around the handlebar and Roto-Stop cable.
Location Distance from pivot bolt

80 mm (3-1/8 in)
 165 mm (6-1/2 in)
 390 mm (15-3/8 in)
RIGHT SIDE
2-24
CABLE TIE
Secure the throttle and drive
cables together 80 mm away
from the pivot bolt.
CABLE TIE (2)
PIVOT BOLT


CABLE TIE (2)
PIVOT
BOLT



WIRE HOLDER
HRN216
LEFT SIDE
OUTSIDE

BLADE
SMART
BRAKE
DRIVE
CABLE
CABLE
UP
BLADE
BRAKE
CABLE

OUTSIDE
OUTSIDE

ROTO-STOP
CABLE